LSM303D 6DoF Motion Sensor Breakout - PIM376

LSM303D 6DoF Motion Sensor Breakout - PIM376

Artikelnr. 58032 Merk Pimoroni Model PIM376 Schrijf een review Share
Pimoroni
€ 8,55€ 7,05 Excl. BTW (NL)
Niet op voorraad Levertijd 5 tot 30 werkdagen
In winkelwagen
Verzonden vanaf € 2,95 (NL) 30 dagen bedenktermijn

Beschrijving Links Bijlagen

LSM303D 6DoF Motion Sensor Breakout - PIM376
This 6 Degrees of Freedom Motion Sensor Breakout can detect acceleration in three axes - X, Y, and Z - as well as three axes of magnetic heading. It's ideal for building into robots, rockets, and rovers, or anywhere else where you want to measure motion accurately. It's compatible with Raspberry Pi or Arduino.

The LSM303D 6DoF Breakout has an I2C interface and is 3.3V or 5V compatible. Like our other Pimoroni breakouts, we've designed it so that you can solder a piece of right-angle header onto it and then pop it straight onto the bottom left 5 pins on your Raspberry Pi's GPIO header (pins 1, 3, 5, 7, 9).
It's also compatible with our fancy new Breakout Garden, where using breakouts is as easy as just popping it into one of the six slots and starting to grow your project, create, and code.

Features
  • LSM303D 6DoF Motion Sensor
  • ±2/±4/±8/±12 gauss magnetic scale
  • ±2/±4/±6/±8/±16 g linear acceleration
  • 16 bit data output
  • 3.3V or 5V compatible
  • I2C interface, with address select via ADDR cuttable trace (0x1D or 0x1E)
  • Reverse polarity protection
  • Raspberry Pi-compatible pinout (pins 1, 3, 5, 7, 9)
  • Compatible with Raspberry Pi 3B+, 3, 2, B+, A+, Zero, and Zero W
  • Python library
  • Datasheet
Kit includes
  • LSM303D 6DoF Motion Sensor Breakout
  • 1x5 male header
  • 1x5 female right angle header
Software
We've put together a Python library that you can use to read data from your LSM303D 6DoF Breakout, and an easy one-line installer to install everything.

Notes
  • The trace between the solder pads (marked ADDR) can be cut (carefully with a craft knife) to change the I2C address from the default of 0x1D to 0x1E, meaning that you can use up to two sensors on the same Raspberry Pi or Arduino. If cut, the pads can be bridged again by soldering to reset the address to 0x1D.
  • Dimensions: 19x19x3mm

Vragen en antwoorden

Klant ervaringen

LSM303D 6DoF Motion Sensor Breakout - PIM376 Klik op een ster om een beoordeling te geven

Laatst bekeken

Webwinkelkeur Kiyoh Tweakers Trustpilot