SparkFun Load Cell Amplifier - HX711

SparkFun Load Cell Amplifier - HX711
  • SparkFun Load Cell Amplifier - HX711 100x80
  • SparkFun Load Cell Amplifier - HX711 100x80
  • SparkFun Load Cell Amplifier - HX711 100x80
  • SparkFun Load Cell Amplifier - HX711 100x80
Sparkfun
Artikelnr.55312
MerkSparkfun
ModelSEN-13879
Voorraad
Nog ... stuks op voorraad
Vandaag voor 23:59 besteld, morgen in huis.
Verzonden vanaf  € 25 - United States
Verkocht per stuk
€ 11,95
In winkelwagen
  • Koop 10 stuks voor € 11,45 per stuk4% korting
  • Koop 25 stuks voor € 10,95 per stuk8% korting
  • Koop 50 stuks voor € 10,45 per stuk13% korting
  • Koop 100 stuks voor € 9,95 per stuk17% korting
  • Koop 500 stuks voor € 9,45 per stuk21% korting

Beschrijving

The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell, and with some calibration you’ll be able to get very accurate weight measurements. This can be handy for creating your own industrial scale, process control or simple presence detection.

This version of the SparkFun Load Cell Amplifier features a few changes that you specifically asked for! We have separated the analog and digital supply, as well as added a 3.3uH inductor and a 0.1uF filter capacitor for digital supply.

The HX711 uses a two-wire interface (Clock and Data) for communication. Any microcontroller’s GPIO pins should work, and numerous libraries have been written, making it easy to read data from the HX711. Check the hookup guide below for more information.

Load cells use a four-wire Wheatstone bridge configuration to connect to the HX711. These are commonly colored RED, BLK, WHT, GRN and YLW. Each color corresponds to the conventional color coding of load cells:
  • Red (Excitation+ or VCC)
  • Black (Excitation- or GND)
  • White (Amplifier+, Signal+ or Output+)
  • Green (A-, S- or O-)
  • Yellow (Shield)
The YLW pin acts as an optional input that is not hooked up to the strain gauge but is utilized to ground and shield against outside EMI (electromagnetic interference). Please keep in mind that some load cells might have slight variations in color coding.

Features:
  • Operation Voltage: 2.7V--5V
  • Operation Current: < 1.5mA
  • Selectable 10SPS or 80SPS output data rate
  • Simultaneous 50 and 60Hz supply rejection

Alternatieven


Bijbehorende producten


Vraag en antwoord

Bijlagen

Beoordelingen

Er zijn nog geen beoordelingen achtergelaten voor dit product .



SparkFun Load Cell Amplifier - HX711Klik op een ster om een beoordeling te geven